#RAD MINI BATTERY UPGRADE ZIP#

Use caution to not damage the cable housing or scratch the frame. Use a flat head screwdriver to carefully unseat the rubber grommet. Unseat the rubber grommet at the lower cable opening of the downtube.Gently feed the cable into the upper cable opening at the front of the downtube. Turn the handlebar to the side and locate the large wiring harness cable at the front of the bike.

#RAD MINI BATTERY UPGRADE ZIP#

Snip zip ties as needed, and unplug each connector by pulling directly apart without twisting. Trace each cable coming out of the bottom of the controller to the connector.

Unplug the battery connector, PAS sensor connector, and motor connector.

Snip zip ties as needed, and unplug the taillight connector by pulling directly apart without twisting. Trace the cable coming out of the top of the controller to the connector.

The replacement controller from Rad Power Bikes.

A Phillips head screwdriver (optional: a stubby screwdriver for easier access),.

Reinstall the battery, check that all cables are free from any moving parts, and test the bike fully before riding.Snip zip tie excess and ensure the cut is flush and smooth. Secure all cables so they are clear of any moving parts. Organize the cables and replace any zip ties.Carefully align the internal notch and pins (and external arrows) and press each side directly together, without twisting, to fully seat the connection. Pass the connectors through the frame stand and toward the back of the bike. Align the internal notch and pins (and external arrows) and press directly together, without twisting, to fully seat the connection. Pass the cable coming out of the top of the controller through the cable guide on the downtube.

Rad mini battery upgrade